Morgan Roadster Luggage Rack :

Revo-Rack Black £329.95 / $379 / €349

Revo-Rack PA £389.95 / $449 / €419.95

Revo-Rack is a unique design of Morgan Roadster Luggage Rack eliminates the risk of paint damage, caused by steel clamps or straps on the boot/trunk lid edge. We manufacture the rack ourselves and its available in either black or polished anodised finish, Revo-Rack has been in manufacture since 2016.

With the Revo-Rack car boot rack no metal touches your Morgan only soft rubber vacuum cups these use the pressure of the atmosphere to secure the rack to your Mogs boot or trunk. Please read what our customers think of the Revo-Rack

Why a Revo-Rack Morgan Roadster Luggage Rack ?

• No clamps
• No bolts
• No drilling
• No paint damage
• In production since 2016 tried tested and enjoyed by thousands of customers gloablly.
• Tested to ISO/PAS 11154:2006 Road vehicles - Roof load carriers & European Directive for the General Safety 2002/95/CE.
• Revo-Racks load carrying capacity has been rated at 20kg / 40Ibs on the Roadster
• Fitted and removed in under a minute ( see video below )
• Not immediately obvious how to release the rack from the boot/trunk lid - Impossible to pull off, therefore theft is difficult.
• If you do stop for a prolonged period and are concerned about your luggage we suggest you remove the rack and luggage and place it inside your car, a 30 second task
• Supplied with two luggage straps and a cotton storage bag

The Rack Frame :

This Morgan Roadster luggage rack is manufactured from 25mm/ 1" 6063-T5 tubing this is an aluminium and magnesium alloy ( it will never rust )  As a result the rack frame weighs only 1.672kg / 3.6lb perfect for todays aluminium and composite boot/trunk lids. The cross bars are machine welded in place to ensure consistency, the rack is powder coated black or hand polished and anodised. The rack measures 900x420mm  /  36"x17"

The Supports :

The rack is secured to your Morgans's boot/trunk lid using three 120mm vacuum cups,  rated by the manufacturer as capable of holding an 18kg/40lb load each.

Vacuum cups employ the force of atmospheric pressure to grip a surface: When a vacuum exists between the cup and the surface on which it is attached, the weight of Earth's atmosphere holds the cup in place with incredible force. Unlike suction cups that produce a vacuum as they pull away from the surface, Revo-Racks vacuum cups use a hand-actuated pump to efficiently remove air from between the rubber pad and the attaching surface thus creating a much more reliable hold. Because the full face of the pad is brought into contact with the boot/trunk lid, distortion is reduced, allowing the cup to be used with very little risk of damage.

The Revo-Racks vacuum cup's pump feature a plunger with a red line, which serves as a vacuum indicator. This safety device is still acknowledged as one of the most reliable warning systems available. A few strokes of the plunger evacuate the vacuum pad, causing it to seal securely to the attaching surface. When the cup is attached completely, the plunger stops moving and the red line is hidden within the pump. A visible red line indicates if air has leaked back into the pad, making vacuum insufficient to use the cup. However, if the red line becomes visible while the cup is in use, a check valve allows the user to re pump the cup without losing the remaining vacuum.

Lifting on the release tab near the edge of the pad allows air to refill the evacuated space, so that the vacuum cup detaches completely. The racks sits 7.5cm / 3" off the boot/trunk lid

Soft rubber cannot chip scratch or mark your Morgan

Vacuum cup pumped and secured to paintwork

Revo-Rack being tested to ISO/PAS 11154:2006 Road vehicles - Roof load carriers & European Directive for the General Safety 2002/95/CE.